P0AE6: Hybrid/EV battery precharge contactor A control circuit low
DIY difficulty 5/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe car may refuse to enter ready mode or shut down without warning — plan on a tow rather than forcing a drive.
Inside the big high-voltage battery are heavy-duty switches that connect the battery to the rest of the car when you power up. This code means the computer can't confirm the high-voltage power path is working right (a control signal stuck too low). Those switches sit inside a pack that carries lethal voltage, so this is professional-only work.
Key facts
P0AE6 means hybrid/EV battery precharge contactor A control circuit low. Inside the big high-voltage battery are heavy-duty switches that connect the battery to the rest of the car when you power up. This code means the computer can't confirm the high-voltage power path is working right (a control signal stuck too low). Those switches sit inside a pack that carries lethal voltage, so this is professional-only work. WrenchFair's published fair-price range for this repair is $125–$1500 parts and $300–$1200 labor at independent shops.
WrenchFair rates P0AE6 a 5-of-5 DIY difficulty (“Shop-only — the fix means opening the sealed high-voltage battery pack, which can kill without training and proper equipment.”) with a “Diagnose soon” driveability rating: The car may refuse to enter ready mode or shut down without warning — plan on a tow rather than forcing a drive. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
ev/hybrid system warning light on
reduced power output or limp mode
charging may fail or be slowed
reduced electric range
Likely causes
control wire shorted to ground
internal short in coil
connector pins corroded - high contact resistance
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Power the car fully off, then treat every orange cable and the battery pack as lethal — high voltage can kill. Only qualified technicians open the pack or service HV parts; your DIY stops at 12V checks, fuses, and connectors you can reach without opening anything. Tests: connector pins corroded - high contact resistance
Check the 12V battery's health and terminal connections — a weak 12V battery is a classic cause of phantom hybrid codes.
When powering on, listen for the contactors clunking as high voltage connects — silence or repeated clicking is a clue.
Check the fuses feeding the battery ECU and the 12V system.
Contactor service means opening the high-voltage pack — technician-only. Get a written estimate.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$125 – $1500
Labor$300 – $1200
control wire shorted to ground. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0AE6 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
5 of 5 — Shop-only — the fix means opening the sealed high-voltage battery pack, which can kill without training and proper equipment.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →