P0995: Transmission fluid pressure sensor/switch F circuit high
DIY difficulty 4/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonFalse high pressure readings make the computer run the transmission soft - slipping burns clutches, so diagnose it soon.
The pressure sensor for another part of your transmission is stuck high - the computer thinks pressure is maxed out and backs off. Expect slipping shifts.
Key facts
P0995 means transmission fluid pressure sensor/switch F circuit high. The pressure sensor for another part of your transmission is stuck high - the computer thinks pressure is maxed out and backs off. Expect slipping shifts. WrenchFair's published fair-price range for this repair is $80–$600 parts and $300–$800 labor at independent shops.
WrenchFair rates P0995 a 4-of-5 DIY difficulty (“A pegged-high live reading confirms the fault; isolating it takes a meter.”) with a “Diagnose soon” driveability rating: False high pressure readings make the computer run the transmission soft - slipping burns clutches, so diagnose it soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
slipping or flaring shifts
delayed engagement
transmission in limp mode
Likely causes
Sensor F signal wire shorted to battery voltage (most common)
Failed pressure sensor F stuck high
Damaged connector with pins bridged to a power wire
Chafed internal transmission harness
Failed PCM/TCM (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Scan all codes and watch sensor F's live reading - a pegged maximum while driving confirms the fault.
Inspect the harness for chafing where the signal wire could touch a 12V feed. Tests: Sensor F signal wire shorted to battery voltage (most common)
Test the signal circuit for a short to power with the meter.
Disconnect the sensor and retest to isolate the short.
Repair the wiring or replace the sensor as the testing indicates.
Pan removal is usually required for sensor access.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $600
Labor$300 – $800
Pressure sensor F circuit short repair (sensor replacement if failed). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0995 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — A pegged-high live reading confirms the fault; isolating it takes a meter.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →