P0994

P0994: Transmission fluid pressure sensor/switch F circuit low

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The pressure sensor for another part of your transmission is shorted low - the computer thinks pressure is near zero and overcompensates. Expect harsh shifts.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Scan all codes and watch sensor F's live reading - a flat zero while driving confirms the fault.
  2. Inspect the harness and connector for chafing and fluid intrusion. Tests: Corroded connector bridging the signal to ground
  3. With power removed, test the sensor signal wire for continuity to ground. Tests: Sensor F signal wire shorted to ground (most common)
  4. Disconnect the sensor and retest - if the short disappears, the sensor is shorted. Tests: Sensor F signal wire shorted to ground (most common)
  5. Repair the wiring or replace the sensor as the testing indicates.
  6. Pan removal is usually required for sensor access.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$80 – $600
Labor$300 – $800

Pressure sensor F circuit short repair (sensor replacement if failed). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0994 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — A flat-zero live reading confirms the fault; isolating it takes a meter.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →