Diagnose soonA shorted actuator circuit can blow fuses and kill the transmission's ability to move the car - trace it promptly.
The wire running your clutch actuator is shorted to ground. Expect the transmission to refuse to shift or engage the clutch.
Key facts
P0902 means clutch actuator circuit low. The wire running your clutch actuator is shorted to ground. Expect the transmission to refuse to shift or engage the clutch. WrenchFair's published fair-price range for this repair is $200–$1500 parts and $400–$1200 labor at independent shops.
WrenchFair rates P0902 a 3-of-5 DIY difficulty (“Disconnecting the actuator to isolate the short is the decisive test.”) with a “Diagnose soon” driveability rating: A shorted actuator circuit can blow fuses and kill the transmission's ability to move the car - trace it promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2012–2018 Ford Focus (2.0L I4 (GDI Duratec Ti-VCT)) — DPS6 PowerShift clutch shudder/judder on light acceleration:Factory-documented
Actuator motors are driveway-able with jack stands (motor B requires lifting the car). Clutch-pack and input-shaft-seal replacement is transmission-out — shop-level; budget accordingly.
Do this test first: Scan all codes and check clutch actuator live data.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for p0902 on the 2012–2018 Ford Focus — but the community-sourced DPS6 PowerShift clutch shudder/judder on light acceleration note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Clutch actuator motor bolts: verify — No factory figure verified in this run — confirm against Ford service info. Small bolts into the transmission case strip easily.
Tips
The signature failure: a shudder or judder on light acceleration, usually 1st-to-2nd, that feels like driving over rumble strips. Causes stack: input-shaft seals leak fluid onto the dry clutches (TSB 14-0197), the clutch packs wear, and TCM/actuator faults mimic it.
Ford's customer satisfaction program 14M01 extended clutch/seal coverage (7 yr/100k from warranty start) — pull any used Focus's OASIS/dealer history; many cars got multiple clutch packs and still shuddered.
Owner-verified driveway work: the two clutch actuator motors (A and B, part AE8Z-7C604-A) bolt to the OUTSIDE of the transmission — no transmission drop. Motor A sits by the battery box, motor B is underneath behind the radiator splash shield. They do not need programming.
Before condemning the clutch: clean and tighten the transmission and battery grounds. Weak grounds throw TCM/actuator codes (P0902) that feel exactly like clutch failure.
The owner 'clutch scrubbing' trick (several hard accelerations through the gears) can temporarily smooth a dry shudder — it is not a fix and not Ford-endorsed. If seals are leaking oil onto the clutch, the shudder comes back.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
transmission will not shift or move the vehicle
clutch will not engage
transmission warning light on
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Actuator control wire shorted to ground (most common)
Shorted clutch A actuator internally 2 owner notes link this repair to P0902
Corroded connector bridging the circuit to ground
Failed PCM/TCM output driver (rare)
Owner notes linked to P0902: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Scan all codes and check clutch actuator live data. Tests: Shorted clutch A actuator internally
Inspect the actuator wiring for chafing where it could short to ground. Tests: Actuator control wire shorted to ground (most common)
With power removed, test the actuator circuit for continuity to ground. Tests: Actuator control wire shorted to ground (most common)
Disconnect the actuator and retest - if the short disappears, the actuator itself is shorted. Tests: Actuator control wire shorted to ground (most common)
Repair the wiring or replace the actuator as the testing indicates.
After repair, run the clutch relearn/adaptation procedure.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2012–2018 Ford Focus: DPS6 PowerShift clutch shudder/judder on light acceleration — test first, then buy for this job.
The price range below is a national planning range for p0902 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$200 – $1500
Labor$400 – $1200
Clutch actuator circuit short repair (actuator replacement if failed). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0902 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Disconnecting the actuator to isolate the short is the decisive test.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →