Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonA relay that never turns off drains the battery - check for a drain and fix it promptly.
The feedback wire from your transmission relay is stuck high - the computer thinks the relay never turns off. Watch for a dead battery overnight.
Key facts
P0891 means tCM power relay sense circuit high. The feedback wire from your transmission relay is stuck high - the computer thinks the relay never turns off. Watch for a dead battery overnight. WrenchFair's published fair-price range for this repair is $20–$300 parts and $120–$400 labor at independent shops.
WrenchFair rates P0891 a 2-of-5 DIY difficulty (“Compare what the relay is actually doing against what the sense line claims.”) with a “Diagnose soon” driveability rating: A relay that never turns off drains the battery - check for a drain and fix it promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
dead battery after sitting
transmission in failsafe/limp mode
relay may feel hot or click constantly
Likely causes
Sense wire shorted to battery voltage (most common)
Failed relay with welded contacts holding the line high
Damaged connector with pins bridged to a power wire
Chafed harness contacting a 12V feed
Failed PCM sense input (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for parasitic battery drain - a sense line held high can accompany a relay stuck on. Tests: Failed relay with welded contacts holding the line high
Verify actual relay behavior with a meter versus what the sense reports.
Swap-test the TCM relay with an identical known-good relay.
Inspect the harness for chafing where the sense wire could touch a 12V feed. Tests: Sense wire shorted to battery voltage (most common)
Check connectors for bridged pins.
Suspect the computer's sense input only after wiring is proven good.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$20 – $300
Labor$120 – $400
TCM power relay replacement or sense-circuit short repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0891 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Compare what the relay is actually doing against what the sense line claims.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →