P0870: Transmission fluid pressure sensor/switch C circuit
DIY difficulty 4/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe computer is shifting without a good pressure reading on this circuit - limp mode is likely, so diagnose it soon.
A third transmission pressure sensor (the 'C' one) has an electrical fault. Expect changed shift feel and possibly limp mode.
Key facts
P0870 means transmission fluid pressure sensor/switch C circuit. A third transmission pressure sensor (the 'C' one) has an electrical fault. Expect changed shift feel and possibly limp mode. WrenchFair's published fair-price range for this repair is $80–$350 parts and $200–$500 labor at independent shops.
WrenchFair rates P0870 a 4-of-5 DIY difficulty (“Connector inspection is easy; the sensor itself is often inside the pan on the valve body.”) with a “Diagnose soon” driveability rating: The computer is shifting without a good pressure reading on this circuit - limp mode is likely, so diagnose it soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
changed shift quality - harsh or soft shifts
transmission starts in 2nd or 3rd gear (limp mode)
check-engine light on
Likely causes
Corroded or damaged external connector at the transmission (most common)
Failed transmission fluid pressure sensor/switch C
Open, shorted, or chafed wiring in the sensor circuit
Internal transmission problems - leaks, stuck valve, low line pressure
Failed PCM/TCM (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for TSBs and companion power or pressure codes - diagnose power faults and multi-sensor codes first. Tests: Failed transmission fluid pressure sensor/switch C
Check fluid level and condition; burnt fluid or debris points to internal problems. Tests: Internal transmission problems - leaks, stuck valve, low line pressure
Locate the TFPS 'C' and inspect its connector and wiring for corrosion, rubbing, and burn spots - external connector corrosion is the most common cause. Tests: Corroded or damaged external connector at the transmission (most common)
Clear the code after cleaning the connector; if it returns, test circuit power, ground, and signal. Tests: Corroded or damaged external connector at the transmission (most common)
Test the sensor against factory specs; replace it if it fails.
If sensor and circuit test good, suspect internal leaks, a stuck valve, or low line pressure.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $350
Labor$200 – $500
Transmission fluid pressure sensor/switch replacement (often requires pan removal). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0870 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Connector inspection is easy; the sensor itself is often inside the pan on the valve body.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →