P083A

P083A: Transmission fluid pressure sensor/switch G circuit

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

One of your transmission's pressure sensors has an electrical fault. Expect changed shift feel and possibly limp mode - the computer is shifting blind on that pressure reading.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for TSBs and any companion power or pressure-sensor codes - diagnose power faults and multi-sensor codes first. Tests: Failed transmission fluid pressure sensor/switch G
  2. Check transmission fluid level and condition; burnt fluid or debris in the pan points to internal problems. Tests: Internal transmission problems - leaks, stuck valve, low line pressure
  3. Locate the TFPS 'G' (valve body or case-mounted per the factory manual) and inspect its connector and wiring for corrosion and damage - external connector corrosion is the most common cause. Tests: Corroded or damaged external connector at the transmission (most common)
  4. Clear the code after cleaning the connector; if it returns, test the sensor circuit power, ground, and signal. Tests: Open, shorted, or chafed wiring in the sensor circuit
  5. Test the sensor itself against factory specs (resistance changes with pressure); replace it if it fails.
  6. If the sensor and circuit test good, suspect internal leaks, a stuck valve, or low line pressure - a transmission specialist job.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$80 – $350
Labor$200 – $500

Transmission fluid pressure sensor/switch replacement (often requires pan removal). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P083A ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Connector inspection is easy; the sensor itself is often inside the pan on the valve body.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →