P0807

P0807: Clutch position sensor A circuit low

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The clutch pedal switch is sending a voltage that is too low - usually a wire shorted to ground. The most common result: you turn the key and nothing happens.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Look up TSBs for the year, make, and model matching this code.
  2. Inspect the pedal-bracket area for a pinched or chafed harness, especially where it passes through the firewall. Tests: Pinched harness where it passes through the firewall or pedal bracket
  3. Disconnect the sensor and check whether the low signal clears - if it does, the sensor itself is the short.
  4. With the circuit de-energized, test the signal wire for continuity to ground; trace and repair the shorted section. Tests: Wiring shorted to ground in the clutch position sensor circuit (most common)
  5. Check connectors for corrosion or bent pins bridging the signal to ground.
  6. Clear the code and verify the starter cranks only with the clutch pressed.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$25 – $120
Labor$80 – $200

Clutch position sensor replacement or shorted-wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0807 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Short-to-ground hunts are methodical multimeter work, but the circuit is small and under the dash.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →