Diagnose soonInternal transmission issue. Continued driving accelerates wear - get it diagnosed soon.
The transmission tried to shift and something went wrong - it didn't land in the right gear cleanly. You'll feel flares, bangs, or the transmission giving up into limp mode.
Model notes: A fluid service is reasonable maintenance and sometimes helps, but be honest with yourself: fresh fluid does not restore worn clutch material.
Key facts
P0780 means shift malfunction. The transmission tried to shift and something went wrong - it didn't land in the right gear cleanly. You'll feel flares, bangs, or the transmission giving up into limp mode. WrenchFair's published fair-price range for this repair is $100–$800 parts and $300–$2500 labor at independent shops.
WrenchFair rates P0780 a 4-of-5 DIY difficulty (“Fluid service first; persistent malfunction after fresh fluid means internal diagnosis.”) with a “Diagnose soon” driveability rating: Internal transmission issue. Continued driving accelerates wear - get it diagnosed soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 528 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Engine And Engine Cooling) — see the latest ones
On your 2016–2021 Honda Civic (1.5L turbo (L15B7), 2.0L (K20C2)) — CVT fluid service:Owner-verified
Drain-and-fill only — Honda does not recommend flushing the CVT (dealers will not flush it even on request). Use genuine Honda HCF-2 fluid only, no substitutes or mixing; each drain removes about 3.9 quarts (owners buy 4 quarts plus a long thin funnel). The drain plug is on the lower driver side of the transmission; the check/level plug (weep hole) sits just forward and above the drain hole — with the car level, refill until fluid dribbles out of the check hole. Some owners remove the airbox and fill from above with the funnel rather than fighting the check-hole fill. The car must be on level ground and the fluid at operating temperature for an accurate level check. Owners report no owner-serviceable filter at routine drain-and-fill intervals, so replace the drain and check-bolt crush washers instead. If the fluid is degraded (low-speed shudder/judder), owners and guides recommend a sequential triple drain-and-fill with HCF-2.
Do this test first: Check fluid level and condition - this code with burnt fluid is a worn transmission
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0780 on the 2016–2021 Honda Civic — but the community-sourced CVT fluid service note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
CVT drain bolt (1.5T): 36 ft-lbs — Per 10th-gen walkthrough video description; confirm against factory service info before torquing.
CVT check/level plug (1.5T): 15 ft-lbs — Per 10th-gen walkthrough video description; confirm against factory service info before torquing.
CVT check/level plug (2.0L): 32 ft-lbs — Per 10th-gen walkthrough video description; confirm against factory service info before torquing.
Tips
Drain-and-fill only — never power-flush a Honda CVT; owners report the transmission is sensitive to flush procedures.
Genuine Honda HCF-2 is mandatory; generic or universal CVT fluid can cause shudder, harsh start-clutch engagement, and accelerated wear.
Set the level with the car level and the transmission at operating temperature — overfilling causes foaming and overheating.
Replace the drain and check-plug crush washers every service; several owners do a CVT drain-and-fill every 30k miles or every other oil change.
Persistent low-speed shudder after a triple drain-and-fill with HCF-2 points to worn variator pulleys or start clutch, not fluid — budget for professional diagnosis.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
shift flares (RPM jumps during shift)
harsh shifts
limp mode
check engine light
delayed engagement when shifting
transmission slipping
whining noise from transmission
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Low or degraded transmission fluid (most common - check first) 11 owner notes link this repair to P0780
Worn clutches slipping during the shift 11 owner notes link this repair to P0780
Failing shift solenoid 11 owner notes link this repair to P0780
Valve body wear 11 owner notes link this repair to P0780
Owner notes linked to P0780: 11 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check fluid level and condition - this code with burnt fluid is a worn transmission Tests: Low or degraded transmission fluid (most common - check first)
Service the fluid and filter if maintenance is overdue, then road test
Log the shift events to identify which shift is failing Tests: Failing shift solenoid
If the malfunction persists with fresh fluid, internal wear or valve body issues need professional diagnosis Tests: Valve body wear
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2016–2021 Honda Civic: CVT fluid service — test first, then buy for this job.
The price range below is a national planning range for P0780 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$100 – $800
Labor$300 – $2500
A fluid service is a few hundred; internal repair runs into the thousands. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0780 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Fluid service first; persistent malfunction after fresh fluid means internal diagnosis.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →