P0776

P0776 on a 2014–2016 Nissan Rogue: Pressure control solenoid B performance/stuck off

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0776 on a 2009–2010 Chevrolet Traverse · 2007–2009 GMC Acadia · 2014–2021 Mitsubishi Outlander · 2013–2018 Nissan Altima · 2014–2016 Nissan Rogue

DIY difficulty 4/5

A second pressure-regulating solenoid is stuck or underperforming. The transmission can't control clutch pressure properly, so shifts slip or bang.

Model notes: A solenoid that tests fine electrically but can't control pressure has either a stuck valve or a worn bore - the hydraulic side, not the electrical side.

Key facts

☑ Before you buy parts — check these first:
On your 2014–2016 Nissan Rogue (2.5L QR25DE) — CVT judder / shudder — P17F0 diagnosis ladder: Owner-verified
Diagnosis starts with a scan and a fluid check; the valve body lives inside the CVT behind the pan. Whether the fix is a valve body or a full unit hinges on the belt inspection.
Do this test first: Check fluid condition - debris points at internal wear beyond the solenoid
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0776 on the 2014–2016 Nissan Rogue — but the community-sourced CVT judder / shudder — P17F0 diagnosis ladder note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: auto press (class action) · Nissan TSB text · owner forum · video guide

Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0776: 5 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check fluid condition - debris points at internal wear beyond the solenoid Tests: Sticking pressure control solenoid B (most common)
  2. Test solenoid resistance and command it with a scan tool while monitoring pressure Tests: Sticking pressure control solenoid B (most common)
  3. If the solenoid tests good electrically but pressure doesn't respond, suspect valve body bore wear Tests: Valve body bore wear
  4. Replace the solenoid; if bore wear is found, the valve body needs professional attention Tests: Valve body bore wear

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2014–2016 Nissan Rogue: CVT judder / shudder — P17F0 diagnosis ladder — test first, then buy for this job.
The price range below is a national planning range for P0776 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$50 – $200
Labor$200 – $600

Solenoid replacement; pan-accessible on many transmissions. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0776 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Performance codes need hydraulic diagnosis, not just resistance checks.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →