Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonHigher RPM and worse mileage. Not immediately dangerous, but don't ignore it.
The clutch inside your torque converter that locks up on the highway for better mileage isn't working. You'll notice higher RPMs at cruise and worse gas mileage.
VW/Audi note (VCDS): TCC slip PID at steady cruise is the whole test: near-zero slip is healthy, hundreds of RPM of slip is a failing lockup.
Model notes: A TCC shudder (vibration at light throttle around 40-50 mph) is the early warning - fresh fluid sometimes helps, but persistent shudder means the clutch lining is worn.
Key facts
P0740 means torque converter clutch circuit malfunction. The clutch inside your torque converter that locks up on the highway for better mileage isn't working. You'll notice higher RPMs at cruise and worse gas mileage. WrenchFair's published fair-price range for this repair is $100–$600 parts and $300–$1200 labor at independent shops.
WrenchFair rates P0740 a 3-of-5 DIY difficulty (“Solenoid testing is DIY; converter replacement is a transmission-out job.”) with a “Diagnose soon” driveability rating: Higher RPM and worse mileage. Not immediately dangerous, but don't ignore it. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
high RPM at highway cruise
poor fuel economy
check engine light
possible shudder
Likely causes
Failed TCC solenoid (most common)
Wiring fault to the transmission
Worn TCC clutch inside the converter
Low fluid or valve body issue preventing lockup
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Monitor TCC slip RPM at steady highway cruise - excessive slip confirms the complaint
Check fluid level and condition
Test the TCC solenoid electrically where accessible Tests: Failed TCC solenoid (most common)
If the solenoid is good but lockup never holds, the converter clutch is worn internally Tests: Worn TCC clutch inside the converter
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$100 – $600
Labor$300 – $1200
Fluid service and solenoid are moderate; converter replacement is major. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0740 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Solenoid testing is DIY; converter replacement is a transmission-out job.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →