Diagnose soonExpect limp mode with limited gears - drive gently to a shop.
The transmission's output speed sensor has gone completely silent. Harsh shifts and limp mode are likely.
Model notes: Check the wiring to the sensor before replacing it - the harness runs near hot exhaust and chafes.
Key facts
P0722 means output speed sensor circuit no signal. The transmission's output speed sensor has gone completely silent. Harsh shifts and limp mode are likely. WrenchFair's published fair-price range for this repair is $40–$150 parts and $200–$500 labor at independent shops.
WrenchFair rates P0722 a 3-of-5 DIY difficulty (“See P0715.”) with a “Diagnose soon” driveability rating: Expect limp mode with limited gears - drive gently to a shop. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2008–2013 Chevrolet Tahoe Hybrid (6.0L V8) — No-start diagnosis (no conventional starter):Owner-verified
Diagnostic only: use a hybrid-aware scan tool and a helper to watch the crankshaft pulley. Do not touch high-voltage hardware for this test.
Do this test first: Compare output speed to wheel speed in live data
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0722 on the 2008–2013 Chevrolet Tahoe Hybrid — but the community-sourced No-start diagnosis (no conventional starter) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Diagnostic fasteners (covers, disconnect): verify — No torque values involved in this diagnostic note.
Tips
Remember there is no conventional 12V starter to fail: the two motor-generators inside the 2ML70 crank the engine through the crankshaft at about 1500 rpm. If you hear nothing from under the hood during a no-start, think hybrid system, not starter motor.
Do the eyeball test: have someone attempt a start while you watch the crankshaft pulley. If the crank is actually spinning and it will not fire, the fault is ignition or fuel, not hybrid. If the crank is not moving, suspect the transmission input/output shaft side.
Pull the matching codes: P16F3, P2160, P077B, and P0722 point at the transmission-side start and speed signals on these trucks.
After any hybrid service work, reseat the orange high-voltage service disconnect on the pack until it gives its full two-step click — a half-seated disconnect is a common no-start cause — and confirm the underhood inverter cover is back on, since a missing cover triggers the interlock and blocks start.
Clearing codes with a generic scanner is not enough after a hybrid shutdown; the dealer needs to run a full computer reset (about an hour) or the shutdown can recur.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Typical time: “Clearing codes with a generic scanner is not enough after a hybrid shutdown; the dealer needs to run a full computer reset (about an hour) or the shutdown can recur.” — as written in the note. First-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
harsh shifting
speedometer issues
limp mode
poor fuel economy
engine feels like it is misfiring
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed output speed sensor
Damaged tone wheel
Wiring fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 1 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Compare output speed to wheel speed in live data Tests: Failed output speed sensor
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2008–2013 Chevrolet Tahoe Hybrid: No-start diagnosis (no conventional starter) — test first, then buy for this job.
The price range below is a national planning range for P0722 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $150
Labor$200 – $500
Sensor replacement; pan removal labor on many transmissions. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0722 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →