Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonA bad sensor reading can cause poor running or stalling. Drive carefully and diagnose soon.
The sensor reporting the transmission's output speed has an electrical fault. Expect wrong shift timing, harsh shifts, or limp mode.
VW/Audi note (VCDS): Graph output speed on a drive; a trace that drops to zero intermittently is the classic failing-sensor pattern.
Model notes: On some vehicles the output speed sensor also feeds the speedometer - a dead speedometer plus shifting complaints points straight here.
Key facts
P0720 means output speed sensor circuit malfunction. The sensor reporting the transmission's output speed has an electrical fault. Expect wrong shift timing, harsh shifts, or limp mode. WrenchFair's published fair-price range for this repair is $30–$120 parts and $80–$200 labor at independent shops.
WrenchFair rates P0720 a 2-of-5 DIY difficulty (“Output sensors are usually external and accessible - one of the easier transmission repairs.”) with a “Diagnose soon” driveability rating: A bad sensor reading can cause poor running or stalling. Drive carefully and diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
erratic shifting
limp mode
speedometer issues on some vehicles
check engine light
Likely causes
Failed output speed sensor (most common)
Wiring damage - these run near hot exhaust and moving parts
Corroded connector
Damaged tone ring
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Watch the output speed PID on a test drive - dropouts or zero confirm the fault Tests: Failed output speed sensor (most common)
Inspect the sensor and wiring for physical damage Tests: Wiring damage - these run near hot exhaust and moving parts
Check the tone ring for damage Tests: Damaged tone ring
Replace the sensor if the circuit tests good but produces no signal
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$30 – $120
Labor$80 – $200
Sensor replacement is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0720 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Output sensors are usually external and accessible - one of the easier transmission repairs.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →