P0715

P0715 on a 2013–2019 Nissan Sentra: Input/turbine speed sensor circuit malfunction

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0715 on a 2013–2019 Nissan Sentra

DIY difficulty 3/5

The transmission can't tell how fast its input shaft is spinning, so shifts get harsh and confused. Check the fluid first.

Model notes: The sensor is often inside the pan - check fluid level and condition first, since low fluid causes similar symptoms.

Key facts

☑ Before you buy parts — check these first:
On your 2013–2019 Nissan Sentra (1.8L (MR18DE), CVT (JF015E)) — CVT fluid service: Owner-verified
The JF015E CVT has no dipstick (deleted starting with the 2013 model year), so everything happens from underneath: a drain plug on the pan and a combined fill/level plug on the side of the pan. Loosen the fill plug FIRST, before touching the drain plug — if the fill plug won't budge after you've drained it, you're stuck. Car must be level for the level check, and fluid is checked at operating temperature through the side fill hole.
Do this test first: Check the sensor signal in scan tool
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0715 on the 2013–2019 Nissan Sentra — but the community-sourced CVT fluid service note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum (BITOG) · owner forum (BITOG) · owner Q&A

Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 2 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check the sensor signal in scan tool
  2. Verify fluid level and condition

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2013–2019 Nissan Sentra: CVT fluid service — test first, then buy for this job.
The price range below is a national planning range for P0715 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$50 – $150
Labor$200 – $500

Sensor is often pan-accessible; fluid and filter service usually done at the same time. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0715 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Sensor is often inside the pan.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →