Diagnose soonVerify real oil pressure before driving far - a lying sensor is common, but real pressure loss is engine-ending.
The sensor watching your oil pressure is giving a bad electrical signal. Do not just assume the sensor is lying - check the oil level and have the pressure verified with a mechanical gauge, because real oil pressure loss wrecks engines fast. If pressure is truly fine, it is the sensor or its wiring.
Key facts
P0523 means engine Oil Pressure Sensor/Switch Circuit High. The sensor watching your oil pressure is giving a bad electrical signal. Do not just assume the sensor is lying - check the oil level and have the pressure verified with a mechanical gauge, because real oil pressure loss wrecks engines fast. If pressure is truly fine, it is the sensor or its wiring. WrenchFair's published fair-price range for this repair is $30–$120 parts and $75–$200 labor at independent shops.
WrenchFair rates P0523 a 2-of-5 DIY difficulty (“Sensor swap is easy; the critical step is verifying real pressure with a gauge.”) with a “Diagnose soon” driveability rating: Verify real oil pressure before driving far - a lying sensor is common, but real pressure loss is engine-ending. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2007–2013 GMC Sierra (5.3L V8 (LC9, LMG, LY5), 6.0L V8, 6.2L V8) — Oil pressure sensor P0521/P0523 (bad reading, not bad pump):Owner-verified
Work over the back of the engine from above - the sensor sits behind the intake manifold at the rear. It is a reach-in blind spot; a cold engine, good light, and the special socket make it a 30-minute job instead of a fight.
Do this test first: Check the oil level first - top up if low.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0523 on the 2007–2013 GMC Sierra — but the community-sourced Oil pressure sensor P0521/P0523 (bad reading, not bad pump) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Oil pressure sensor: verify — Snug into the galley - verify the spec in GM service info; overtightening cracks the sensor body.
Tips
Check your oil level FIRST. One owner's P0521 chase ended when he found the truck was 2.5 quarts low - topping up fixed the code. Low oil mimics a bad sensor, and the gauge lying about pressure is the oldest trap on these trucks.
The sensor lives under a screen at the back of the engine, behind the intake manifold. That screen clogs with sludge and starves the sensor of oil, so the gauge reads 0 or sticks low even with good pressure. Unscrew the sensor, pull the screen with a pick, and clean or replace it - many owners fix the code with the screen alone.
Buy the sensor with the screen included (ACDelco 12673134 with the round connector is the one owners confirm for the 5.3L), and get the special oil pressure sensor socket - a regular socket will round or crack the sensor body.
P0521 means the sensor signal is out of plausible range; P0523 means it is stuck high. Both usually trace to the same sensor-and-screen spot. If the code returns with a new sensor and clean screen, check the wiring pigtail and connector for corrosion before suspecting the pump.
Expect to pay about $50 in parts and 30 minutes of your time on a cold engine, versus a shop visit for the same fix. The sensor is a wear item on these trucks - owners expect to replace it again eventually, and there is no relocation kit.
Typical difficulty: Moderate — based on 841 code guides for the sensors repair area (an area-level estimate, not this exact job).
Typical time: “Expect to pay about $50 in parts and 30 minutes of your time on a cold engine, versus a shop visit for the same fix.” — as written in the note. First-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
oil pressure warning light or gauge acting up
check engine light on
ticking from low oil (if real)
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
failed oil pressure sensor
wiring fault in the sensor circuit
low oil level
corroded connector
actually low oil pressure (verify!)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the oil level first - top up if low.
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Verify actual oil pressure with a mechanical gauge at the sensor port. Tests: failed oil pressure sensor
If pressure is normal, test the sensor circuit and replace the sensor. Tests: failed oil pressure sensor
If pressure is truly low, stop and diagnose the oiling system - do not drive.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2007–2013 GMC Sierra: Oil pressure sensor P0521/P0523 (bad reading, not bad pump) — test first, then buy for this job.
The price range below is a national planning range for P0523 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $120
Labor$75 – $200
Oil pressure sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0523 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Sensor swap is easy; the critical step is verifying real pressure with a gauge.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →