P0496

P0496 on a 2009–2023 Chevrolet Traverse: Evaporative emission system high purge flow

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0496 on a 2019–2019 Buick Enclave · 2020–2025 Buick Encore GX · 2009–2023 Chevrolet Traverse · 2006–2017 Kia Rio

DIY difficulty 2/5

The valve controlling gas fumes is stuck open, letting fumes flood the engine when they shouldn't. Expect hard starting right after you fill up with gas.

Model notes: Hard starting immediately after refueling is the signature symptom - if that matches, go straight to the purge valve blow-through test.

Key facts

☑ Before you buy parts — check these first:
On your 2009–2023 Chevrolet Traverse (3.6L V6) — EVAP purge solenoid — hard start after refueling (P0496): Owner-verified
One of the easiest engine-bay jobs on the Traverse — on top of the intake manifold on the driver's side near the throttle body. 10mm socket, flathead screwdriver, about 20 minutes.
Do this test first: Remove the purge valve and try to blow through it with no power applied - any airflow means it is stuck open
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0496 on the 2009–2023 Chevrolet Traverse — but the community-sourced EVAP purge solenoid — hard start after refueling (P0496) note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: tech Q&A · repair guide · video guide

Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).

Typical time: “10mm socket, flathead screwdriver, about 20 minutes.” — as written in the note. First-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0496: 4 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Remove the purge valve and try to blow through it with no power applied - any airflow means it is stuck open Tests: Purge valve stuck open (most common)
  2. Check that the correct part number is fitted
  3. Verify the ECM is not commanding it open constantly (wiring short) Tests: ECM commanding purge due to a sensor fault (rare)
  4. Replace the valve and confirm the hard-start-after-refuel symptom is gone

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2009–2023 Chevrolet Traverse: EVAP purge solenoid — hard start after refueling (P0496) — test first, then buy for this job.
The price range below is a national planning range for P0496 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$15 – $80
Labor$0 – $180

Gas cap is under $25; smoke test plus hose/valve runs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0496 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — The blow-through test with the valve unpowered is definitive and takes minutes.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →