Drive safeEmissions-only fault. Safe to drive - fix at your convenience (often just the gas cap).
The valve controlling gas fumes is stuck open, letting fumes flood the engine when they shouldn't. Expect hard starting right after you fill up with gas.
Model notes: Hard starting immediately after refueling is the signature symptom - if that matches, go straight to the purge valve blow-through test.
Key facts
P0496 means evaporative emission system high purge flow. The valve controlling gas fumes is stuck open, letting fumes flood the engine when they shouldn't. Expect hard starting right after you fill up with gas. WrenchFair's published fair-price range for this repair is $15–$80 parts and $0–$180 labor at independent shops.
WrenchFair rates P0496 a 2-of-5 DIY difficulty (“The blow-through test with the valve unpowered is definitive and takes minutes.”) with a “Drive safe” driveability rating: Emissions-only fault. Safe to drive - fix at your convenience (often just the gas cap). These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2020–2025 Buick Encore GX (1.2L I3 turbo (LIH), 1.3L I3 turbo (L3T)) — EVAP purge pump failure (P0496 / P1467):Owner-verified
The purge pump sits in the engine bay EVAP line and is held by a single 10mm bolt plus two hose connections — owners report it as a straightforward driveway swap.
Do this test first: Remove the purge valve and try to blow through it with no power applied - any airflow means it is stuck open
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0496 on the 2020–2025 Buick Encore GX — but the community-sourced EVAP purge pump failure (P0496 / P1467) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Purge pump mounting bolt: verify — No published torque value found in owner sources — snug the 10mm bolt and confirm hose clamps are seated; verify against factory service info.
Tips
Check for special coverage N232395310 BEFORE paying: certain 2020–2021 Encore GX (1.2L/1.3L) get a free purge pump replacement for 15 years or 150,000 miles. Multiple owners had it done free, one three months past bumper-to-bumper.
P1467 (purge pump underspeed) is the pump itself dying. Owners report the updated pump (part 25207556, superseding 12703879) costs around $35–$40 and swaps with one 10mm bolt; clear the code with a scanner and drive to confirm it stays off.
P0496 on the 1.3T points at the purge solenoid, not the pump. GM bulletin PIP6037A says check the solenoid O-rings and hose connections at the pump and solenoid first, then test for leaks between the solenoid and the turbo inlet duct. If a leak is confirmed, replace the purge solenoid AND the air inlet duct together with the latest parts — do not try to separate the solenoid from the duct.
P146F is usually a wiring issue, not a parts failure. TSB 21-NA-014 says the cause is high resistance in the purge pump ground circuit; the fix is relocating the ground wire to a new spot on the engine block. The bulletin explicitly says not to replace the EVAP canister until the ground has been relocated.
A failed pump can saturate the vapor canister with fuel, so do not keep driving for months with the light on — the repair snowballs from a pump into a pump plus canister.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
hard starting after refueling
rough idle
check engine light
fuel smell
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Purge valve stuck open (most common) 4 owner notes link this repair to P0496
Purge valve seal degraded 4 owner notes link this repair to P0496
Incorrect aftermarket purge valve 4 owner notes link this repair to P0496
ECM commanding purge due to a sensor fault (rare) 4 owner notes link this repair to P0496
Owner notes linked to P0496: 4 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Remove the purge valve and try to blow through it with no power applied - any airflow means it is stuck open Tests: Purge valve stuck open (most common)
Check that the correct part number is fitted
Verify the ECM is not commanding it open constantly (wiring short) Tests: ECM commanding purge due to a sensor fault (rare)
Replace the valve and confirm the hard-start-after-refuel symptom is gone
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2020–2025 Buick Encore GX: EVAP purge pump failure (P0496 / P1467) — test first, then buy for this job.
The price range below is a national planning range for P0496 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$15 – $80
Labor$0 – $180
Gas cap is under $25; smoke test plus hose/valve runs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0496 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — The blow-through test with the valve unpowered is definitive and takes minutes.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →