Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
DIY difficulty 1/5
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0442-VAG ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
Drive safeEmissions-only fault. Safe to drive - fix at your convenience (often just the gas cap).
The fuel tank cannot hold pressure - a small leak in the evaporative emissions system. Start with the gas cap.
VCDS tip: Clear the code after a gas-cap fix and complete two drive cycles before retesting.
Model notes: Brand patterns: on Volvos the leak detection pump is a common culprit; on Chrysler/Jeep it is the ESIM module; on Hyundai and GM the purge valve.
Key facts
P0442 means eVAP small leak detected. The fuel tank cannot hold pressure - a small leak in the evaporative emissions system. Start with the gas cap. WrenchFair's published fair-price range for this repair is $15–$500 parts and $0–$400 labor at independent shops.
WrenchFair rates P0442 a 1-of-5 DIY difficulty (“Gas cap first; smoke test if it persists.”) with a “Drive safe” driveability rating: Emissions-only fault. Safe to drive - fix at your convenience (often just the gas cap). These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
fuel smell
Likely causes
Loose or cracked gas cap (check first, always)
Cracked EVAP hoses
Leaking purge (N80) or vent valve
Rusty filler neck
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 3 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Tighten/replace the gas cap and drive two cycles before anything else
Smoke-test the EVAP system
Command the vent valve closed in output tests Tests: Leaking purge (N80) or vent valve
Typical price range
Parts$15 – $500
Labor$0 – $400
A gas cap is under $25, but a real shop bill — a $60-$150 smoke test plus a purge/vent valve at $150-$400 installed, or a canister at $300-$700+ installed — typically lands $200-$400. The ranges above span all paths; match the tier to your situation. National-average estimate. Actual quotes vary by vehicle, region, and shop — get a local written estimate. Corrected 2026-10-09 against real-world price evidence (Phase 2 adversarial audit).
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →