Drive safeNo driveability impact - emissions only. Fix before your inspection is due.
The little electric valve that routes fresh air into the exhaust has an electrical problem - the computer tried to operate it and the circuit did not behave. Think of it like a light switch whose wiring is broken: the bulb (pump) may be fine, but the switch circuit is not.
Key facts
P0412 means secondary Air Injection System Switching Valve A Circuit. The little electric valve that routes fresh air into the exhaust has an electrical problem - the computer tried to operate it and the circuit did not behave. Think of it like a light switch whose wiring is broken: the bulb (pump) may be fine, but the switch circuit is not. WrenchFair's published fair-price range for this repair is $80–$250 parts and $100–$200 labor at independent shops.
WrenchFair rates P0412 a 2-of-5 DIY difficulty (“Electrical circuit testing with a multimeter; the valve is usually accessible.”) with a “Drive safe” driveability rating: No driveability impact - emissions only. Fix before your inspection is due. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 776 factory bulletins on file for this vehicle (mostly Equipment, Structure, Electrical System) — see the latest ones
On your 2009–2015 Toyota Tacoma (4.0L 1GR-FE V6, 2.7L 2TR-FE I4) — Secondary air injection failure (P2440/P0418):Owner-verified
The air switching valve sits on the side of the engine head near the exhaust manifold (12mm nuts, one tucked behind the valve); the pump and relay live in the engine-bay fuse/relay area. No intake removal needed for the relay test.
Do this test first: Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0412 on the 2009–2015 Toyota Tacoma — but the community-sourced Secondary air injection failure (P2440/P0418) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Air switching valve nuts: verify — 12mm nuts per owner writeup; torque spec not confirmed from a forum source — confirm against factory service info before torquing.
Tips
Check the relay first — a documented owner fix traced P2440 to a failed #55 relay: swap it with the horn relay (#40) and see if the horn misbehaves with the suspect relay in its place. Minutes, nearly free, and it has cleared the code.
A valve stuck open puts the truck in limp mode; moisture, pump debris, and carbon are the usual causes. Also check the small hose between the valve and the pressure sensor — a deteriorated hose sets the same family of codes.
Out of warranty, the owner consensus is the Hewitt-Tech bypass kit (~$145, about an hour to install, splices into the MAF harness) versus roughly $2,500 for the dealer's whole-system replacement — multiple owners report 10k+ miles trouble-free. Honest note: it's an emissions-system bypass, so check your state's inspection rules before going that route.
Warning repeated across threads: do not buy cheap aftermarket SAIS valves — owners report them failing in weeks to months, some warrantied two or three times before giving up. Toyota replaces the system as a unit because one failing part sends debris through the rest.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
Typical time: “Out of warranty, the owner consensus is the Hewitt-Tech bypass kit (~$145, about an hour to install, splices into the MAF harness) versus roughly $2,500 for the dealer's whole-system replacement — multiple owners report…” — as written in the note. First-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light on
no noticeable driving symptoms
failed emissions test
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
failed switching valve solenoid
open or shorted wiring in the valve circuit
corroded or loose connector at the valve
blown fuse feeding the valve circuit
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Visually inspect the wiring, connectors, and hoses around the component for damage, corrosion, chafing, loose pins, or disconnection. Tests: corroded or loose connector at the valve
Check the related fuses and relays before condemning any part - an open fuse is a cheap fix.
Unplug the valve and check the solenoid's resistance against spec only if your manual lists one; compare with the other valve if there are two.
Check for power and ground at the valve connector while the computer commands it on.
Suspect the PCM only after every wire and component test passes - module failure is rare.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2009–2015 Toyota Tacoma: Secondary air injection failure (P2440/P0418) — test first, then buy for this job.
The price range below is a national planning range for P0412 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$80 – $250
Labor$100 – $200
Secondary air switching valve replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0412 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Electrical circuit testing with a multimeter; the valve is usually accessible.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →