P0344: Camshaft position sensor A circuit intermittent, bank 1
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonMisfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving.
The sensor watching the camshaft keeps dropping its signal intermittently. Expect occasional rough running and longer cranking before it starts.
VW/Audi note (VCDS): Graph camshaft position actual vs desired on VVT engines; a sensor that cannot track commanded position will show as a wandering actual value.
Model notes: On VVT engines, always check oil level and condition with cam sensor codes - sludge or low oil causes phaser problems that mimic sensor faults.
Key facts
P0344 means camshaft position sensor A circuit intermittent, bank 1. The sensor watching the camshaft keeps dropping its signal intermittently. Expect occasional rough running and longer cranking before it starts. WrenchFair's published fair-price range for this repair is $30–$120 parts and $80–$180 labor at independent shops.
WrenchFair rates P0344 a 2-of-5 DIY difficulty (“Cam sensors are usually accessible on the timing cover or valve cover; diagnosis is straightforward.”) with a “Diagnose soon” driveability rating: Misfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
intermittent rough running
extended cranking
check engine light that comes and goes
VVT-related codes appearing alongside
bucking or surging while driving
stalls then immediately restarts
Likely causes
Failing cam sensor with intermittent output (most common)
Loose connector or oil-contaminated connector
Chafed wiring near the timing cover
Low engine oil level or sludge affecting VVT phaser response (on VVT engines)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the connector for oil intrusion - a leaking sensor or VVT solenoid can oil-foul the plug Tests: Loose connector or oil-contaminated connector
Wiggle-test the harness with the engine running
Check engine oil level and condition - VVT systems punish neglected oil Tests: Low engine oil level or sludge affecting VVT phaser response (on VVT engines)
Replace the sensor if the signal drops out with good wiring
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$30 – $120
Labor$80 – $180
Camshaft/crankshaft position sensor or wiring repair is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0344 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Cam sensors are usually accessible on the timing cover or valve cover; diagnosis is straightforward.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →