DIY difficulty 3/5
| What it means | The second bump-detection sensor has an electrical fault. |
|---|---|
| Most common cause | Failed rough-road sensor B (most common) |
| Can you drive? | Yes. |
| Severity | Low |
| DIY cost (parts only) | $40 – $120 |
| Shop cost (parts + labor) | $90 – $270 |
| DIY difficulty | 3 of 5 — Mirror of the 'A' sensor diagnosis. |
Yes. P0319 doesn't make your car unsafe to drive on its own. Monitoring only - fix when convenient. Fix it when convenient rather than putting it off indefinitely — even a minor fault can turn into a bigger bill if the underlying cause gets worse.
Low. WrenchFair rates this one “Drive safe” — the least serious of its three driveability ratings. It's a fix-on-your-schedule fault, not a same-day emergency. Monitoring only - fix when convenient.
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
The second bump-detection sensor has an electrical fault.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Work these checks before spending money — each one rules a cause in or out, cheapest first.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Rough-road sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
Got a shop quote? Grade it →
Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.
Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.
As an Amazon Associate, WrenchFair earns from qualifying purchases.