Diagnose soonMisfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving.
Misfire isolated to one cylinder. The fastest DIY test on a VAG engine is the coil swap: move the suspect coil to another cylinder, clear codes, drive, and see if the misfire follows.
VW/Audi note (VCDS): After a coil swap, misfire counters confirm which cylinder is actually missing before you spend money.
Model notes: Same logic for P0302-P0306; only the cylinder number changes. On the A7 3.0T, cylinders 1-3 are bank 1 (passenger side).
Key facts
P0301-P0306 means cylinder 1 misfire detected. Misfire isolated to one cylinder. The fastest DIY test on a VAG engine is the coil swap: move the suspect coil to another cylinder, clear codes, drive, and see if the misfire follows. WrenchFair's published fair-price range for this repair is $30–$120 parts and $80–$180 labor at independent shops.
WrenchFair rates P0301-P0306 a 2-of-5 DIY difficulty (“Coil swap test takes 15 minutes and prevents buying parts blindly.”) with a “Diagnose soon” driveability rating: Misfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
rough idle
misfire on one cylinder
flashing check engine light
hesitation
harder to start
Likely causes
Bad ignition coil on that cylinder (most common)
Fouled or worn spark plug
Carbon-fouled intake valve on that cylinder
Failing fuel injector
Low compression (worn rings/valves - consider at very high mileage)
Wiring fault to the coil
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Swap the coil from the misfiring cylinder to a known-good cylinder Tests: Bad ignition coil on that cylinder (most common)
Clear codes and drive until the fault returns
If the misfire moved, replace that coil; if it stayed, investigate plug, injector, compression, or carbon on that cylinder Tests: Bad ignition coil on that cylinder (most common)
Check the spark plug condition - it tells you what is happening in that cylinder Tests: Fouled or worn spark plug
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$30 – $120
Labor$80 – $180
Coils and spark plugs are the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →