Diagnose soonA dead cylinder dumps raw fuel into the exhaust - fix it promptly to save the catalytic converter.
The fuel injector for cylinder 7 has an electrical fault - that cylinder is misfiring. Expect rough running and a flashing check engine light.
Key facts
P0207 means injector circuit fault, cylinder 7. The fuel injector for cylinder 7 has an electrical fault - that cylinder is misfiring. Expect rough running and a flashing check engine light. WrenchFair's published fair-price range for this repair is $50–$300 parts and $100–$400 labor at independent shops.
WrenchFair rates P0207 a 3-of-5 DIY difficulty (“A noid light and multimeter isolate this quickly.”) with a “Diagnose soon” driveability rating: A dead cylinder dumps raw fuel into the exhaust - fix it promptly to save the catalytic converter. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2004–2005 GMC Sierra HD (6.6L LLY Duramax V8 diesel) — LLY injector harness connector failure, cylinders #2 and #7:Owner-verified
Connector kits available from GM dealers and diesel specialty vendors; the repair is basic hand tools plus a scan tool to confirm codes.
Do this test first: Use a noid light on the cylinder 7 injector connector
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0207 on the 2004–2005 GMC Sierra HD — but the community-sourced LLY injector harness connector failure, cylinders #2 and #7 note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Injector connector repair: verify — Electrical repair; no torque spec applies. Seat connectors fully and route the harness clear of chafe points.
Tips
On the 2004.5-2005 LLY Duramax, the #2 and #7 fuel injector connectors are a known failure point. When a connector opens intermittently, the truck suddenly loses power, knocks loudly, and barely rolls; owners report it feels like the engine is crippled. Restarting the truck often clears it temporarily because the fault is vibration-dependent.
The ECM's response makes it dramatic: when it detects the injector circuit fault (P0202, P0207, P2146, P2149), it shuts down half the injectors to keep the engine balanced, which is what causes the heavy knocking and power loss. Do not keep driving it hard in that state.
The root causes documented by owners and vendors: sloppy terminal crimps, poorly seated wire insulators, and terminals that fracture from engine vibration. The wiring can also chafe where the harness routes over the valve covers, so inspect the loom for rub-through before condemning the connector.
GM released a connector repair kit covering the #2 and #7 injectors (two connectors, brackets, and instructions), available through Chevrolet/GMC dealers. Aftermarket vendors also sell upgraded pigtail connectors built with genuine Bosch housings and high-temp GXL wire as a permanent fix.
The owner workaround known as the 'ice pick trick' (gently re-tensioning the connector pins) is widely reported to buy time, but the real fix is replacing the connectors. Check and clean the pins at every injector connector while you are in there.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light (may flash)
steady misfire on cylinder 7
rough running
loss of power
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed cylinder 7 fuel injector (most common)
Damaged wiring to the cylinder 7 injector
Corroded injector connector
Failed injector driver in the ECM (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Use a noid light on the cylinder 7 injector connector Tests: Failed cylinder 7 fuel injector (most common)
Measure the injector's resistance against factory spec
Inspect the wiring from the ECM to the injector Tests: Damaged wiring to the cylinder 7 injector
Swap the injector with another cylinder to see if the misfire follows Tests: Failed cylinder 7 fuel injector (most common)
Replace the injector or repair the wiring as indicated
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2004–2005 GMC Sierra HD: LLY injector harness connector failure, cylinders #2 and #7 — test first, then buy for this job.
The price range below is a national planning range for P0207 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$50 – $300
Labor$100 – $400
Fuel injector replacement (cylinder 7). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0207 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — A noid light and multimeter isolate this quickly.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →