P0199: Engine oil temperature sensor circuit intermittent
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonNo immediate driveability impact - fix at your convenience.
Your oil temperature sensor cuts in and out - usually a loose or oil-fouled connector.
Key facts
P0199 means engine oil temperature sensor circuit intermittent. Your oil temperature sensor cuts in and out - usually a loose or oil-fouled connector. WrenchFair's published fair-price range for this repair is $30–$150 parts and $80–$250 labor at independent shops.
WrenchFair rates P0199 a 2-of-5 DIY difficulty (“Check for oil in the connector - it's a classic cause on pan-mounted sensors.”) with a “Diagnose soon” driveability rating: No immediate driveability impact - fix at your convenience. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light that comes and goes
Likely causes
Loose, corroded, or oil-fouled sensor connector (most common)
Wire with an internal break that opens with vibration
Sensor with an intermittent internal fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Inspect the connector for oil contamination and clean it Tests: Loose, corroded, or oil-fouled sensor connector (most common)
Wiggle-test the connector and harness while monitoring the reading Tests: Loose, corroded, or oil-fouled sensor connector (most common)
Inspect connector pins for spread or corrosion Tests: Loose, corroded, or oil-fouled sensor connector (most common)
Replace the sensor if the dropout is internal Tests: Sensor with an intermittent internal fault
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$30 – $150
Labor$80 – $250
Engine oil temperature sensor or connector repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0199 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Check for oil in the connector - it's a classic cause on pan-mounted sensors.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →