P0172

P0172 on a 2019–2024 Acura RDX: System too rich, bank 1

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0172 on a 2019–2024 Acura RDX

DIY difficulty 3/5

Can I drive with P0172?

Can I drive with a P0172 code?

Short trips and gentle driving only, until you know the cause. Rich running washes oil off cylinder walls and can overheat the catalytic converter. Diagnose soon. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.

How serious is P0172?

Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. Rich running washes oil off cylinder walls and can overheat the catalytic converter. Diagnose soon.

Will P0172 go away on its own?

The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.

Your engine is running rich on bank 1 - too much fuel. You'll smell fuel and your gas mileage will tank. Often a leaking injector or a stuck-open purge valve.

Model notes: Pull the spark plugs - a black, wet plug identifies the guilty cylinder. Check the EVAP purge valve for being stuck open.

Key facts

☑ Before you buy parts — check these first:
On your 2019–2024 Acura RDX (2.0L turbo (K20C4)) — 1.5T-style fuel dilution (rising oil level) + cold-start misfire/P0172 - TSB B23-010 software update: Factory-documented
Driveway: check the dipstick monthly - if the oil level is RISING or smells strongly of gas, change it early. Dealer: TSB B23-010 (2019-2023 RDX) covers a free PGM-FI software update plus an oil change for cold-start misfire/P0172 - check iN VIN eligibility before paying for injectors or coils.
Do this test first: Check fuel trims: rich at idle points to purge valve or PCV; rich under load points to injector or high fuel pressure
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0172 on the 2019–2024 Acura RDX — but the community-sourced 1.5T-style fuel dilution (rising oil level) + cold-start misfire/P0172 - TSB B23-010 software update note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Tips

Sources: BobIsTheOilGuy - 2020 RDX used-oil analysis showing persistent high fuel dilution on the 2.0T · TSB B23-010 (Mar 2023) - Software update for DTC P0300-P0304/P0172, 2019-2023 RDX (NHTSA PDF) · AcuraZine - 2020 RDX TSB index (lists B23-010 among 3rd-gen bulletins)

Typical difficulty: Moderate — based on 5 code guides for the oil repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 3 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check fuel trims: rich at idle points to purge valve or PCV; rich under load points to injector or high fuel pressure Tests: Leaking fuel injector
  2. Pull spark plugs - a black wet plug identifies the guilty cylinder
  3. Check the EVAP purge (EVAP purge valve) valve for being stuck open Tests: EVAP purge valve (EVAP purge valve) stuck open

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2019–2024 Acura RDX: 1.5T-style fuel dilution (rising oil level) + cold-start misfire/P0172 - TSB B23-010 software update — test first, then buy for this job.
The price range below is a national planning range for P0172 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$30 – $250
Labor$120 – $350

Purge valve is cheap; injector replacement costs more, especially on direct injection. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0172 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Injector diagnosis is moderate; injector replacement on direct-injection engines is involved.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

🔌 Read your spark plugs This code names the unhappy system; your plugs show what the combustion actually looks like. Pull one and match it to the visual chart — how to read your spark plugs →
Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →