P0167: O2 sensor heater circuit fault, bank 2 sensor 3
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Drive safeEmissions-monitoring only - no driveability impact.
The heater inside your third oxygen sensor (bank-2 side) isn't working. The car drives normally.
Key facts
P0167 means o2 sensor heater circuit fault, bank 2 sensor 3. The heater inside your third oxygen sensor (bank-2 side) isn't working. The car drives normally. WrenchFair's published fair-price range for this repair is $40–$150 parts and $80–$180 labor at independent shops.
WrenchFair rates P0167 a 2-of-5 DIY difficulty (“Confirm the vehicle has a sensor 3; fuse check plus circuit testing.”) with a “Drive safe” driveability rating: Emissions-monitoring only - no driveability impact. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
no driveability symptoms
Likely causes
Failed heater element inside the sensor (most common)
Damaged wiring
Blown O2 heater fuse
Corroded connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Confirm sensor 3 exists on your vehicle
Check the O2 heater fuse Tests: Blown O2 heater fuse
Inspect the wiring and connector Tests: Corroded connector
Measure the heater element resistance against factory spec Tests: Failed heater element inside the sensor (most common)
Replace the sensor if the element is dead
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$80 – $180
Oxygen sensor replacement (bank 2 sensor 3). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0167 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Confirm the vehicle has a sensor 3; fuse check plus circuit testing.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →