P013C: O2 sensor slow response rich-to-lean, bank 1 sensor 2
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Drive safeCatalyst monitoring only - no driveability impact.
Your rear oxygen sensor is too slow switching from rich to lean - it's aging or contaminated. The car drives fine; it only watches the catalytic converter.
Key facts
P013C means o2 sensor slow response rich-to-lean, bank 1 sensor 2. Your rear oxygen sensor is too slow switching from rich to lean - it's aging or contaminated. The car drives fine; it only watches the catalytic converter. WrenchFair's published fair-price range for this repair is $40–$130 parts and $80–$160 labor at independent shops.
WrenchFair rates P013C a 2-of-5 DIY difficulty (“Confirm with a scan tool before replacing.”) with a “Drive safe” driveability rating: Catalyst monitoring only - no driveability impact. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
no driveability symptoms
possible failed emissions test
Likely causes
Aging downstream O2 sensor (most common)
Contaminated sensor
Weak sensor heater
Exhaust leak near the sensor
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Watch the sensor's rich-to-lean transition time on a scan tool
Check for exhaust leaks near the sensor Tests: Exhaust leak near the sensor
Verify heater operation
Replace the sensor if transitions are slow with no other cause
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $130
Labor$80 – $160
Downstream oxygen sensor replacement (bank 1 sensor 2). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P013C ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Confirm with a scan tool before replacing.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →