P0124: Throttle/pedal position sensor intermittent
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonSudden power cuts in traffic are a safety issue - diagnose this promptly.
Your throttle position signal cuts in and out - usually a worn sensor or loose connector. Expect sudden power cuts or surges while driving.
Model notes: On drive-by-wire vehicles there are two pedal sensors and two throttle sensors for redundancy - the ECM flags when they disagree or glitch.
Key facts
P0124 means throttle/pedal position sensor intermittent. Your throttle position signal cuts in and out - usually a worn sensor or loose connector. Expect sudden power cuts or surges while driving. WrenchFair's published fair-price range for this repair is $40–$350 parts and $80–$250 labor at independent shops.
WrenchFair rates P0124 a 2-of-5 DIY difficulty (“Sweep-test the sensor with a multimeter or scan tool - a dead spot shows up as a jump in the reading.”) with a “Diagnose soon” driveability rating: Sudden power cuts in traffic are a safety issue - diagnose this promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
sudden power loss or surging
hesitation on acceleration
possible limp mode
Likely causes
Worn throttle position sensor with a dead spot (most common)
Loose or corroded throttle/pedal connector
Wire with an internal break that opens with vibration
Carbon-fouled throttle body causing erratic readings
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Wiggle-test the throttle and pedal connectors while watching position readings Tests: Loose or corroded throttle/pedal connector
Slowly sweep the throttle and watch for jumps or dropouts in the signal Tests: Worn throttle position sensor with a dead spot (most common)
Clean carbon from the throttle body Tests: Carbon-fouled throttle body causing erratic readings
Inspect the wiring for chafing
Replace the throttle position sensor (or throttle body if integrated) if the track is worn
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $350
Labor$80 – $250
Throttle position sensor or throttle body replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0124 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Sweep-test the sensor with a multimeter or scan tool - a dead spot shows up as a jump in the reading.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →