P005E: Turbocharger boost control 'B' supply voltage low
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe turbo can't be controlled properly without solid power - diagnose soon.
Can I drive with P005E?
Can I drive with a P005E code?
Short trips and gentle driving only, until you know the cause. The turbo can't be controlled properly without solid power - diagnose soon. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.
How serious is P005E?
Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. The turbo can't be controlled properly without solid power - diagnose soon.
Will P005E go away on its own?
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
The power feed for your second turbo's boost control is too weak - a bad relay, corroded fuse, or tired wiring is starving it. Expect boost problems on that turbo.
Key facts
P005E means turbocharger boost control 'B' supply voltage low. The power feed for your second turbo's boost control is too weak - a bad relay, corroded fuse, or tired wiring is starving it. Expect boost problems on that turbo. WrenchFair's published fair-price range for this repair is $10–$60 parts and $80–$180 labor at independent shops.
WrenchFair rates P005E a 2-of-5 DIY difficulty (“Voltage-drop testing under load finds the weak link.”) with a “Diagnose soon” driveability rating: The turbo can't be controlled properly without solid power - diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
loss of power
possible limp mode
Likely causes
Failing boost control relay
Corroded fuse holder or fuse
High-resistance wiring or ground in the supply circuit
Another component on the shared feed dragging voltage down
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Confirm dual boost control on your vehicle Tests: Failing boost control relay
Measure the 'B' supply voltage under load and compare to battery voltage Tests: Another component on the shared feed dragging voltage down
Voltage-drop test across the relay, fuse, and wiring Tests: Another component on the shared feed dragging voltage down
Clean or replace corroded fuse holders and connectors Tests: Corroded fuse holder or fuse
Replace the relay if voltage drops across it
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$10 – $60
Labor$80 – $180
Boost control relay or supply wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P005E ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Voltage-drop testing under load finds the weak link.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →