P0050

P0050: O2 sensor heater circuit fault, bank 2 sensor 1

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The little heater inside your front oxygen sensor (bank-2 side, before the catalytic converter) isn't working. The car runs fine once warmed up, but fuel fine-tuning is delayed on that bank.

Model notes: Bank 2 sensor 1 is the upstream sensor on the side opposite cylinder 1, before the catalytic converter.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check the O2 heater fuse first Tests: Blown fuse in the O2 heater power feed
  2. Visually inspect the bank 2 sensor 1 wiring and connector for heat damage or corrosion Tests: Corroded sensor connector
  3. With the key on and engine off, check for battery voltage at the heater power feed wire Tests: Blown fuse in the O2 heater power feed
  4. Unplug the sensor and measure the heater element resistance against factory spec Tests: Failed heater element inside the bank 2 sensor 1 oxygen sensor (most common)
  5. Check the heater ground/control circuit back to the ECM for opens
  6. Replace the sensor if the heater element is dead

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $150
Labor$80 – $180

Upstream oxygen sensor replacement (bank 2 sensor 1). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0050 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — O2 sensor replacement is straightforward with an O2 sensor socket; the diagnosis is a fuse check plus basic circuit testing.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: O2 sensors: typically 35–50 Nm (26–37 lb-ft) — verify spec. A dab of nickel anti-seize on the threads; keep it off the sensor tip.

Pro tip: Route the new sensor’s harness exactly like the old one — melted wires on the exhaust are the number-one comeback.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →