Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonLimp mode is driveable but slow - find the short soon, since a blown fuse can cascade into more codes.
Your boost control wiring is shorted to ground, so the turbo can't be regulated. Expect a big power loss and limp mode.
Key facts
P0047 means turbocharger boost control 'A' circuit low. Your boost control wiring is shorted to ground, so the turbo can't be regulated. Expect a big power loss and limp mode. WrenchFair's published fair-price range for this repair is $40–$150 parts and $80–$200 labor at independent shops.
WrenchFair rates P0047 a 2-of-5 DIY difficulty (“Unplug the solenoid to separate a harness short from a coil short.”) with a “Diagnose soon” driveability rating: Limp mode is driveable but slow - find the short soon, since a blown fuse can cascade into more codes. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
severe loss of power
limp mode
Likely causes
Boost control solenoid wiring shorted to ground
Shorted solenoid coil
Chafed harness near hot turbo or exhaust parts
Corroded connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the fuse feeding the solenoid Tests: Boost control solenoid wiring shorted to ground
Unplug the solenoid and see if the short-to-ground reading clears Tests: Boost control solenoid wiring shorted to ground
Test the control wire for continuity to ground and repair chafed sections Tests: Boost control solenoid wiring shorted to ground
Measure the solenoid coil resistance against factory spec Tests: Shorted solenoid coil
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$80 – $200
Boost control solenoid replacement or wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0047 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Unplug the solenoid to separate a harness short from a coil short.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →