P0042

P0042: O2 sensor heater circuit fault, bank 1 sensor 3

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The heater inside your third oxygen sensor (a second downstream sensor some cars have) isn't working. It only monitors emissions equipment, so the car drives normally.

Model notes: Sensor 3 positions vary (post second catalyst, or between catalyst bricks). Check the factory manual for the exact location on your vehicle.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Confirm your vehicle is equipped with a bank 1 sensor 3 - many aren't, and a phantom code suggests a scan-tool misread Tests: Failed heater element inside the bank 1 sensor 3 oxygen sensor (most common)
  2. Check the O2 heater fuse Tests: Blown fuse in the O2 heater power feed
  3. Inspect the sensor 3 wiring for heat damage
  4. Verify battery voltage at the heater feed with the key on Tests: Blown fuse in the O2 heater power feed
  5. Measure the heater element resistance against factory spec and replace the sensor if bad

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $150
Labor$80 – $180

Oxygen sensor replacement (bank 1 sensor 3). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0042 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Same diagnosis as any O2 heater code; just confirm your vehicle actually has a sensor 3 before ordering parts.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: O2 sensors: typically 35–50 Nm (26–37 lb-ft) — verify spec. A dab of nickel anti-seize on the threads; keep it off the sensor tip.

Pro tip: Route the new sensor’s harness exactly like the old one — melted wires on the exhaust are the number-one comeback.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →