P0035: Turbocharger bypass valve control circuit high
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonCompressor surge stresses the turbo - address it soon, but normal driving is fine.
The turbo vent valve's circuit is reading too much voltage. The valve may be stuck, causing flutter or stumbling when you lift off the throttle.
Key facts
P0035 means turbocharger bypass valve control circuit high. The turbo vent valve's circuit is reading too much voltage. The valve may be stuck, causing flutter or stumbling when you lift off the throttle. WrenchFair's published fair-price range for this repair is $60–$250 parts and $80–$200 labor at independent shops.
WrenchFair rates P0035 a 2-of-5 DIY difficulty (“Standard circuit testing; the valve is usually easy to reach.”) with a “Diagnose soon” driveability rating: Compressor surge stresses the turbo - address it soon, but normal driving is fine. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
flutter or surge noise on throttle lift
loss of boost response
Likely causes
Bypass valve wire shorted to battery voltage
Failed bypass valve solenoid (open)
Open in the ECM-controlled ground side
Corroded or damaged connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Inspect the valve connector and wiring Tests: Corroded or damaged connector
Verify proper voltage and ECM ground control at the connector with the key on Tests: Bypass valve wire shorted to battery voltage
Unplug the valve to isolate a harness fault from a valve fault
Trace the harness for chafing against power feeds
Replace the valve if the solenoid is open or mechanically stuck
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$60 – $250
Labor$80 – $200
Turbocharger bypass valve replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0035 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Standard circuit testing; the valve is usually easy to reach.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →