P0016

P0016 on a 2012–2018 Mercedes-Benz GLE: Crankshaft position - camshaft position correlation, bank 1

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0016 on a 2010–2017 Chevrolet Equinox · 2009–2012 Chevrolet Traverse · 2011–2014 Ford F-150 · 2015–2019 Ford Transit · 2007–2012 GMC Acadia · 2012–2014 Mercedes-Benz C-Class
Show all 8 vehicles with this code

2012–2018 Mercedes-Benz GLE · 2010–2014 Volkswagen Golf/GTI

DIY difficulty 5/5

Can I drive with P0016?

Can I drive with a P0016 code?

No. Minimize driving until diagnosed. If you hear chain rattle on cold start or the engine runs poorly, park it - a jumped timing chain can destroy an interference engine. Have it towed rather than driven. (The only exception is moving the car a few feet to a safe spot, then shutting the engine off.)

How serious is P0016?

High. WrenchFair rates this one “Stop driving” — the most serious rating, reserved for faults that can strand you or cause real damage if you keep driving. Minimize driving until diagnosed. If you hear chain rattle on cold start or the engine runs poorly, park it - a jumped timing chain can destroy an interference engine.

Will P0016 go away on its own?

The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.

More detail: can I drive with P0016? →

Your engine's timing chain has stretched or a guide is failing - the cam and crank are out of sync. On most modern engines this can cause catastrophic damage if the chain jumps. Don't ignore this one.

Model notes: Check oil level immediately - low oil starves the chain tensioner. Listen for chain rattle on cold start.

Key facts

☑ Before you buy parts — check these first:
On your 2012–2018 Mercedes-Benz GLE (3.5L V6 M276, 3.0L V6 twin-turbo M276 (GLE 400)) — M276 cold-start rattle / camshaft adjuster wear (P0016, P0011): Owner-verified
Front timing-cover job — valve covers and front of the engine come apart. Camshaft locking tools are required; this is an advanced DIY or a specialist job.
Do this test first: Check oil level immediately
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0016 on the 2012–2018 Mercedes-Benz GLE — but the community-sourced M276 cold-start rattle / camshaft adjuster wear (P0016, P0011) note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum (W166 ML 350 timing thread) · repair video (GLE 400 M276 P001685) · specialist guide

Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0016: 8 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 3 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check oil level immediately
  2. Listen for chain rattle on cold start
  3. Check cam adaptation values in scan tool

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2012–2018 Mercedes-Benz GLE: M276 cold-start rattle / camshaft adjuster wear (P0016, P0011) — test first, then buy for this job.
The price range below is a national planning range for P0016 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$200 – $600
Labor$800 – $2000

Timing chain kit plus major labor. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0016 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

5 of 5 — Timing chain replacement is major surgery.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →