Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Drive safeCheck all tire pressures with a gauge regularly until the system is back.
Your tire-pressure warning light comes on and no tire pressures display. Check all four tires manually with a gauge.
Key facts
C0910 means tPMS Receiver Circuit Malfunction. Your tire-pressure warning light comes on and no tire pressures display. Check all four tires manually with a gauge. WrenchFair's published fair-price range for this repair is $120–$400 parts and $100–$250 labor at independent shops.
WrenchFair rates C0910 a 3-of-5 DIY difficulty (“The receiver is usually behind a trim panel — find it, check its wiring, then replace.”) with a “Drive safe” driveability rating: Check all tire pressures with a gauge regularly until the system is back. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
tpms warning light on
no tire pressures displayed
system fault message
Likely causes
TPMS receiver failed
antenna lead open or shorted
wiring fault
module lost power
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Check the receiver's fuse, power, and ground.
2. Inspect the antenna lead and connector. Tests: antenna lead open or shorted
3. If power is good and it still won't receive, replace the receiver. Tests: TPMS receiver failed
4. Relearn the sensors to the new receiver. Tests: TPMS receiver failed
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$120 – $400
Labor$100 – $250
TPMS receiver replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0910 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — The receiver is usually behind a trim panel — find it, check its wiring, then replace.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →