C059B: Brake Pressure Sensor B Missing Calibration
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonBase braking works, but electronic brake assists are degraded — get it diagnosed soon.
Brake-system warnings come on. The pedal still stops the car, but the computer can't measure braking force properly, so its assist features back off.
Key facts
C059B means brake Pressure Sensor B Missing Calibration. Brake-system warnings come on. The pedal still stops the car, but the computer can't measure braking force properly, so its assist features back off. WrenchFair's published fair-price range for this repair is $0–$50 parts and $75–$175 labor at independent shops.
WrenchFair rates C059B a 2-of-5 DIY difficulty (“Calibration is a scan-tool procedure — no parts unless the sensor is dead.”) with a “Diagnose soon” driveability rating: Base braking works, but electronic brake assists are degraded — get it diagnosed soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
brake system warning light on
brake assist reduced
hill hold unavailable
Likely causes
calibration never performed after replacement
calibration lost after module reset
module replaced and never calibrated
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Watch the sensor's live pressure reading while pressing the pedal slowly — it should rise smoothly from near zero.
2. Compare against the redundant sensor if the vehicle has one.
3. Check the sensor's connector, supply voltage, and ground.
4. Run the pressure sensor calibration procedure with a capable scan tool. Tests: calibration never performed after replacement
5. Road-test to confirm.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$0 – $50
Labor$75 – $175
Brake pressure sensor calibration. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C059B ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Calibration is a scan-tool procedure — no parts unless the sensor is dead.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →