C056D: Brake Pedal Position Sensor Supply Voltage Circuit Low
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonBraking still works, but assist features may misbehave — get it diagnosed soon.
Brake-system warnings come on and assist features like hill hold may quit. The pedal sensor is starved of proper power.
Key facts
C056D means brake Pedal Position Sensor Supply Voltage Circuit Low. Brake-system warnings come on and assist features like hill hold may quit. The pedal sensor is starved of proper power. WrenchFair's published fair-price range for this repair is $10–$120 parts and $80–$200 labor at independent shops.
WrenchFair rates C056D a 3-of-5 DIY difficulty (“Power-supply faults are wiring hunts — a multimeter and the wiring diagram are the tools.”) with a “Diagnose soon” driveability rating: Braking still works, but assist features may misbehave — get it diagnosed soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
brake system warning light on
hill hold unavailable
cruise control may not work
Likely causes
short to ground in the supply wiring
corroded connector dropping voltage
module supply driver weak
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Check the relevant fuse first — it's the cheapest fix.
2. Measure supply voltage right at the sensor connector. Tests: corroded connector dropping voltage
3. Trace the supply wire back toward the module, checking for breaks, chafing, and corrosion. Tests: module supply driver weak
4. Repair the wiring or fuse and confirm the sensor reads correctly.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$10 – $120
Labor$80 – $200
Pedal sensor supply wiring or fuse repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C056D ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Power-supply faults are wiring hunts — a multimeter and the wiring diagram are the tools.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →