Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonStability assist is degraded — drive conservatively, especially in rain or snow.
Stability and traction warnings come on. The car feels normal in everyday driving, but the computer can't fully watch for skids without this sensor.
Key facts
C0555 means lateral Accelerometer Voltage Out of Range. Stability and traction warnings come on. The car feels normal in everyday driving, but the computer can't fully watch for skids without this sensor. WrenchFair's published fair-price range for this repair is $80–$250 parts and $80–$200 labor at independent shops.
WrenchFair rates C0555 a 3-of-5 DIY difficulty (“Usually a straightforward sensor swap once you've confirmed the wiring is good.”) with a “Diagnose soon” driveability rating: Stability assist is degraded — drive conservatively, especially in rain or snow. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
stability control warning light on
traction control light on
esc disabled message
Likely causes
supply wiring fault
module supply driver issue
short in the sensor
corroded connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Check the sensor's mounting and connector. Tests: corroded connector
2. Measure supply and signal at the sensor connector and compare with the wiring diagram. Tests: supply wiring fault
3. Trace the wiring for shorts, opens, or chafing.
4. Replace the sensor if power, ground, and wiring all check out.
5. Calibrate if the service procedure requires it, then road-test.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $250
Labor$80 – $200
Accelerometer replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0555 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Usually a straightforward sensor swap once you've confirmed the wiring is good.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →