C0499

C0499: Lateral Acceleration Sensor Range/Performance

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

A sensor that tells your car how it is moving (lateral acceleration sensor) isn't sending a believable signal. Your normal brakes work fine, but stability control is switched off, so the car won't help correct a skid.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Scan all modules and fix any other sensor codes first - one bad sensor can make the module distrust this one. Tests: module fault is possible but uncommon - rule out wiring, mounting, and calibration first
  2. 2. Check whether the car recently had an alignment, suspension, or collision work: lost calibration is the most common cause. Tests: sensor calibration lost after alignment or suspension work - recalibrate before replacing…
  3. 3. Inspect the lateral acceleration sensor mounting and connector for looseness, corrosion, or damage. Tests: lateral acceleration sensor failed
  4. 4. With a scan tool, read the lateral acceleration sensor live data and compare it to reality (straight road, level ground, wheels straight). Tests: lateral acceleration sensor failed
  5. 5. Run the sensor calibration or zero-point learn procedure with a scan tool that supports it.
  6. 6. If it won't calibrate or the signal stays wrong, replace the lateral acceleration sensor and calibrate the new one.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$100 – $400
Labor$120 – $350

A yaw or acceleration sensor replacement with calibration, roughly $250-$600 installed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0499 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Inspection and calibration checks are DIY-friendly; replacement often needs a scan tool with a calibration routine.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →