C0267

C0267: Brake Pump Motor Circuit

DIY difficulty 5/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The electric pump inside your ABS unit that powers anti-lock braking isn't working right. Your normal brakes work fine, but ABS, traction control, and stability control are switched off.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Turn the key on (engine off) and listen at the hydraulic unit: you should hear the pump run its brief self-test. Silence points at the motor or its power supply. Tests: corroded power or ground connection at the hydraulic unit
  2. 2. Check the ABS pump fuse and relay in the under-hood fuse box, including the socket for corrosion. Tests: pump relay failed or welded (where the relay is serviceable separately)
  3. 3. Inspect the heavy power and ground wires at the hydraulic control unit for corrosion, looseness, or heat damage. Tests: corroded power or ground connection at the hydraulic unit
  4. 4. With a scan tool, try commanding the pump motor on through ABS bidirectional controls. Tests: pump motor seized, often after the car sat unused for a long stretch
  5. 5. If power and ground are good but the motor won't run, the pump motor (usually serviced as part of the hydraulic unit) needs replacement, followed by a brake bleed.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$350 – $1100
Labor$200 – $550

A remanufactured hydraulic unit with pump, roughly $700-$1,500 installed with a brake bleed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0267 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

5 of 5 — Checking fuses, relays, and connections is easy DIY; replacing the unit means brake lines and a full bleed.

Watch this repair on YouTube

Parts & tools

ABS / wheel-speed toolkit — what the job actually takes

Torque specs: Wheel-speed sensor bolts: typically 8–12 Nm. (Caliper bracket bolts are far tighter — 90–140 Nm — don’t confuse them.)

Pro tip: Inspect the tone ring/reluctor for cracks and debris first — the sensor itself is often innocent.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →