Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonSteering still works, but assist may fade. Check the fluid level right away - running dry kills the pump.
The sensor watching your power steering pump pressure isn't sending a believable signal. Steering still works, but assist may feel inconsistent.
Key facts
C0250 means power Steering Pump Pressure. The sensor watching your power steering pump pressure isn't sending a believable signal. Steering still works, but assist may feel inconsistent. WrenchFair's published fair-price range for this repair is $60–$250 parts and $100–$250 labor at independent shops.
WrenchFair rates C0250 a 4-of-5 DIY difficulty (“Fluid checks are easy; pump replacement is a moderate DIY or a shop job.”) with a “Diagnose soon” driveability rating: Steering still works, but assist may fade. Check the fluid level right away - running dry kills the pump. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
steering feels heavy or inconsistent
power steering warning light on
whining noise when turning
Likely causes
pressure sensor or switch failed
wiring fault to the sensor
low power steering fluid
worn power steering pump
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Check the power steering fluid level and condition first. Tests: low power steering fluid
2. Listen for pump whine or groaning when turning.
3. Inspect the pressure sensor wiring and connector for damage. Tests: pressure sensor or switch failed
4. Check the drive belt tension and condition.
5. If fluid and belt are good but pressure reads wrong, the sensor or pump needs replacement.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$60 – $250
Labor$100 – $250
A pressure sensor replacement runs $150-$350 installed; a pump replacement runs $300-$600 installed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0250 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Fluid checks are easy; pump replacement is a moderate DIY or a shop job.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →