Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonYour regular brakes keep working normally, but ABS, traction control, and stability control are probably disabled until this is fixed. Drive gently on wet or slippery roads.
The fine pressure control your ABS uses to pulse the brakes isn't working right. Your normal brakes work fine, but ABS and stability control are switched off.
Key facts
C0244 means pWM Brake Pressure Modulation Circuit. The fine pressure control your ABS uses to pulse the brakes isn't working right. Your normal brakes work fine, but ABS and stability control are switched off. WrenchFair's published fair-price range for this repair is $100–$500 parts and $150–$350 labor at independent shops.
WrenchFair rates C0244 a 4-of-5 DIY difficulty (“Control-circuit diagnosis needs a wiring diagram and patience.”) with a “Diagnose soon” driveability rating: Your regular brakes keep working normally, but ABS, traction control, and stability control are probably disabled until this is fixed. Drive gently on wet or slippery roads. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
abs warning light on
traction control or stability control light on
cruise control stops working
Likely causes
wiring fault in the PWM control circuit
module output driver failed
hydraulic valve not responding to modulation commands
low system voltage - check the battery first
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Check battery voltage and charging system first. Tests: low system voltage - check the battery first
2. Scan for wheel speed sensor codes and fix those first.
3. Try commanding pressure modulation with ABS bidirectional controls. Tests: wiring fault in the PWM control circuit
4. Trace the PWM control wiring for chafing or breaks. Tests: wiring fault in the PWM control circuit
5. If wiring is good, the module driver or hydraulic valve is suspect.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$100 – $500
Labor$150 – $350
A wiring or valve repair, roughly $300-$700 at a shop. Module replacement runs higher. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0244 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Control-circuit diagnosis needs a wiring diagram and patience.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →