Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonYour brakes work fine, but dead or stuck-on brake lights are a real safety issue for drivers behind you. This is a cheap, quick fix.
Your brake light switch isn't working right - a cheap part that a lot of systems depend on. Check your brake lights: they may be stuck on or not working at all.
Key facts
C0136 means stop Lamp Switch Circuit. Your brake light switch isn't working right - a cheap part that a lot of systems depend on. Check your brake lights: they may be stuck on or not working at all. WrenchFair's published fair-price range for this repair is $15–$50 parts and $60–$150 labor at independent shops.
WrenchFair rates C0136 a 2-of-5 DIY difficulty (“Usually two screws and a connector at the brake pedal - one of the easiest repairs there is.”) with a “Diagnose soon” driveability rating: Your brakes work fine, but dead or stuck-on brake lights are a real safety issue for drivers behind you. This is a cheap, quick fix. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
brake lights stuck on or not working
cruise control won't engage
abs or traction control light on
shifter stuck in park (automatics)
Likely causes
stop lamp switch failed or misadjusted (most common - it's a cheap wear part)
blown brake light fuse
wiring fault to the switch
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Have someone watch your brake lights while you press the pedal - stuck on or dark confirms it. Tests: blown brake light fuse
3. Inspect the switch at the top of the brake pedal for proper contact and adjustment.
4. Test the switch with a multimeter or just replace it - it's inexpensive. Tests: stop lamp switch failed or misadjusted (most common - it's a cheap wear part)
5. Clear the code and confirm the brake lights work normally.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$15 – $50
Labor$60 – $150
A stop lamp switch replacement, often under $150 installed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0136 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Usually two screws and a connector at the brake pedal - one of the easiest repairs there is.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →