Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonIf it only sets on very slippery roads, the system is doing its job. If it sets on dry pavement, get the hydraulic unit checked.
Your ABS ran much longer than it should during a stop. On glare ice that's normal; on dry roads it means a sensor or the hydraulic unit needs attention.
Key facts
C0111 means aBS Activation Excessively Long. Your ABS ran much longer than it should during a stop. On glare ice that's normal; on dry roads it means a sensor or the hydraulic unit needs attention. WrenchFair's published fair-price range for this repair is $80–$600 parts and $100–$300 labor at independent shops.
WrenchFair rates C0111 a 4-of-5 DIY difficulty (“Ruling out road conditions and sensor issues is DIY; hydraulic block work is a shop job.”) with a “Diagnose soon” driveability rating: If it only sets on very slippery roads, the system is doing its job. If it sets on dry pavement, get the hydraulic unit checked. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
abs warning light on
abs pulsing felt during normal braking
traction control or stability control light on
Likely causes
extremely slippery road surface (normal - most common)
internal leak in the hydraulic block keeping pressure modulation going
wheel speed sensor feeding noisy data
damaged tone ring
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Consider the road: ice or deep gravel sets this legitimately. Clear and retest on dry pavement.
2. Scan for wheel speed sensor codes and fix those first. Tests: wheel speed sensor feeding noisy data
3. Inspect tone rings for damage. Tests: damaged tone ring
4. If it returns on dry roads with good sensors, the hydraulic block has an internal leak and needs replacement. Tests: internal leak in the hydraulic block keeping pressure modulation going
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $600
Labor$100 – $300
Often a sensor issue ($150-$350 installed). A hydraulic block replacement runs $800-$1,800 installed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0111 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Ruling out road conditions and sensor issues is DIY; hydraulic block work is a shop job.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →