C0090

C0090: Hydraulic Brake Pressure Sensor Circuit

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The sensor reading your brake system's hydraulic pressure is sending readings the computer doesn't trust. Your normal brakes work, but ABS and stability control are likely switched off.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Check the brake fluid level and condition first. Tests: module fault is possible but uncommon - check the sensor and wiring first
  2. 2. Watch the pressure sensor in scan tool live data while pressing the brake pedal - it should rise smoothly with effort. Tests: brake pressure sensor failed
  3. 3. Inspect the sensor wiring and connector for damage or corrosion. Tests: wiring fault to the sensor
  4. 4. If the signal is dead, stuck, or out of range with good wiring and fluid, the sensor (often serviced with the hydraulic unit) needs replacement. Tests: wiring fault to the sensor

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$100 – $350
Labor$150 – $350

A brake pressure sensor repair, roughly $300-$600 installed. If it's part of the hydraulic unit, costs run higher. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0090 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Fluid and wiring checks are DIY; the sensor is often part of the hydraulic unit.

Watch this repair on YouTube

Parts & tools

ABS / wheel-speed toolkit — what the job actually takes

Torque specs: Wheel-speed sensor bolts: typically 8–12 Nm. (Caliper bracket bolts are far tighter — 90–140 Nm — don’t confuse them.)

Pro tip: Inspect the tone ring/reluctor for cracks and debris first — the sensor itself is often innocent.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →