Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonOverheated brakes fade and stop worse. Let them cool before hard use, and fix any dragging caliper promptly.
Your brakes got hot enough that the computer noticed - typically from hard use like towing or long downhill stretches. Let them cool down before leaning on them hard again.
Key facts
C0072 means brake Temperature Too High. Your brakes got hot enough that the computer noticed - typically from hard use like towing or long downhill stretches. Let them cool down before leaning on them hard again. WrenchFair's published fair-price range for this repair is $0–$150 parts and $60–$200 labor at independent shops.
WrenchFair rates C0072 a 2-of-5 DIY difficulty (“Cooling down and checking for a dragging caliper are easy DIY checks.”) with a “Diagnose soon” driveability rating: Overheated brakes fade and stop worse. Let them cool before hard use, and fix any dragging caliper promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
brake temperature or abs warning on the dash
hot brake smell
brake fade (soft pedal)
Likely causes
sustained hard braking, towing, or long downhill grades (most common)
a dragging brake caliper overheating one corner
old brake fluid with a low boiling point
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Let the brakes cool fully, clear the code, and retest under normal driving.
2. After a normal drive, check each wheel's temperature - one much hotter wheel means a dragging caliper. Tests: a dragging brake caliper overheating one corner
3. Inspect that caliper's slide pins and piston for seizing.
4. Check brake fluid condition; old fluid boils sooner. Tests: old brake fluid with a low boiling point
5. If it sets without hard use, the temperature estimation model or a related sensor needs diagnosis.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$0 – $150
Labor$60 – $200
Often no repair is needed. A dragging caliper repair runs $150-$400 per corner. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0072 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Cooling down and checking for a dragging caliper are easy DIY checks.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →