Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe sensor is usually telling the truth: the pads are worn. Keep driving and you'll be into the rotors, which costs more.
Your car's brake pad wear sensor is tripped - usually because the pads are actually worn down and due for replacement. Your brakes still work, but don't put this off.
Key facts
C004A means brake Lining Wear Sensor. Your car's brake pad wear sensor is tripped - usually because the pads are actually worn down and due for replacement. Your brakes still work, but don't put this off. WrenchFair's published fair-price range for this repair is $40–$150 parts and $80–$200 labor at independent shops.
WrenchFair rates C004A a 3-of-5 DIY difficulty (“Pad and sensor replacement is classic beginner-friendly brake work.”) with a “Diagnose soon” driveability rating: The sensor is usually telling the truth: the pads are worn. Keep driving and you'll be into the rotors, which costs more. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
brake pad warning light on
squealing from the brakes
thin brake pads on inspection
Likely causes
brake pads worn to the sensor (the sensor doing its job - most common)
wear sensor wire broken or chafed
corroded sensor connector
sensor not replaced with the last pad change
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Inspect pad thickness at all four wheels - if they're at the sensor, replacement is the fix.
2. Check the wear sensor wire for breaks or chafing if the pads still have life. Tests: wear sensor wire broken or chafed
3. Inspect the sensor connector for corrosion. Tests: corroded sensor connector
4. Replace pads and wear sensors as a set; the sensor is one-time use. Tests: brake pads worn to the sensor (the sensor doing its job - most common)
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$80 – $200
A brake pad replacement with new wear sensors, roughly $150-$300 per axle at an independent shop. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C004A ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Pad and sensor replacement is classic beginner-friendly brake work.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →