Diagnose soonYour regular brakes keep working normally, but ABS, traction control, and stability control are probably disabled until this is fixed. Drive gently on wet or slippery roads.
Your car's ABS computer is getting a confusing speed reading from the right front wheel — the numbers don't match the other wheels. Your normal brakes work fine, but ABS and traction control may be switched off.
Key facts
C0041 means right Front Wheel Speed Sensor Circuit Range/Performance. Your car's ABS computer is getting a confusing speed reading from the right front wheel — the numbers don't match the other wheels. Your normal brakes work fine, but ABS and traction control may be switched off. WrenchFair's published fair-price range for this repair is $40–$180 parts and $90–$250 labor at independent shops.
WrenchFair rates C0041 a 3-of-5 DIY difficulty (“Sensor and harness work with basic hand tools; seized sensors and corroded connectors are the usual fights.”) with a “Diagnose soon” driveability rating: Your regular brakes keep working normally, but ABS, traction control, and stability control are probably disabled until this is fixed. Drive gently on wet or slippery roads. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 258 factory bulletins on file for this vehicle (mostly Electrical System, Equipment, Power Train) — see the latest ones
On your 2021–2026 Nissan Rogue (1.5T VC-Turbo (KR15DDT)) — Front brake pads & rotors:Owner-verified
Lug/wheel nuts torque to 83 ft-lb (113 N·m) per the 2022 Rogue owner's manual (T33). Rogue disc-brake hardware pattern (from iFixit's 2013–2026 Rogue disc-brake guide, rear shown — confirm on the front axle): slider-pin bolts have 14mm heads, with the rubber-bushed pin on the bottom; caliper carrier bolts are 17mm. Both are commonly corroded — an impact wrench or breaker bar helps. T33 rotors commonly rust-bond to the hub — the Rogue disc-brake guide flags rotor removal as the hard part of the job. Soak the hub/rotor interface with penetrating oil, wire-brush the hub face before reinstalling, and use a mallet rather than prying against the dust shield.
Do this test first: 1. Clear the code, drive above about 15 mph, and re-scan. Only spend money if the code comes back.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for C0041 on the 2021–2026 Nissan Rogue — but the community-sourced Front brake pads & rotors note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Wheel (lug) nuts: 83 ft-lb (113 N·m) — Per the 2022 Rogue owner's manual (T33).
Front caliper bracket (torque member) bolts: verify — No verifiable T33 factory torque figure found — verify against the Nissan service manual. Do NOT reuse T32-era (2014–2020) torque figures found online; they are a different generation.
Front caliper guide/slider pin bolts: verify — No verifiable T33 factory torque figure found — verify against the Nissan service manual before tightening.
Tips
Clean and re-grease the slide pins with high-temp brake grease during the job — sticking pins are a common cause of uneven pad wear on these Rogues.
Break in new pads with a series of moderate-speed stops and cool-down periods per your pad manufacturer's instructions. (No T33-specific factory bedding procedure was verifiable in research.)
Typical difficulty: Moderate — based on 265 code guides for the brake repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
abs warning light on
traction control or stability control light on
cruise control stops working
speedometer may read wrong
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
mismatched tire sizes fooling the plausibility check
damaged tone ring giving wrong pulse counts
failing wheel speed sensor
low tire pressure on one wheel
ABS module failure is possible but uncommon - rule out wiring and sensors first
Owner notes linked to C0041: 3 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Clear the code, drive above about 15 mph, and re-scan. Only spend money if the code comes back.
2. Watch the right front wheel speed in ABS live data at low speed. A dead, jumpy, or mismatched reading confirms the problem corner. Tests: failing wheel speed sensor
3. Unplug the right front sensor and inspect the connector for corrosion, moisture, or bent pins.
4. Inspect the tone (reluctor) ring through the sensor hole or behind the hub: look for cracked, missing, or rust-packed teeth, and clean out debris. Tests: damaged tone ring giving wrong pulse counts
5. Trace the sensor harness along the wheel-arch flex point and look for chafing, cracks, or old repairs.
6. If the wiring and tone ring check out, replace the right front wheel speed sensor — it is the most common fix.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2021–2026 Nissan Rogue: Front brake pads & rotors — test first, then buy for this job.
Expensive fork: Brake caliper — if a wheel drags or overheats after fresh pads and rotors.
The price range below is a national planning range for C0041 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $180
Labor$90 – $250
A wheel speed sensor replacement, often $150-$350 installed at an independent shop. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0041 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Sensor and harness work with basic hand tools; seized sensors and corroded connectors are the usual fights.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →