Community-sourced DIY repair guides for the 2014–2020 Ram 3500, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Driveway diagnosis — check the air filter, CAC hoses, and MAP sensor first. The actuator itself is a bolt-on part but must be calibrated to the turbo with a scan tool afterward.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
Torque specs
VGT actuator / MAP sensor fasteners: verify — Torque spec not confirmed from a forum source — confirm against factory service info when replacing the actuator.
Tips
Before pricing a turbo, work the cheap end of the P0299 diagnostic tree on 2014-2020 trucks: confirm the air filter is the correct OEM part for your generation (see the regen note), inspect the hot-side charge-air-cooler hose for cracks or splits (Mopar 52014734AC, $50-250), and pull and clean the MAP sensor — soot from the EGR clogs it and it sends false boost readings.
If those check out, the Holset VGT actuator itself is the common failure ($400-800 for the part, Holset 5579127H). The actuator must be calibrated to the turbo with a scan tool after install — one owner replaced his with an aftermarket actuator and cleared P0299/P010C after calibration.
GM-style gotcha: with the actuator removed, work the sector gear on the turbo by hand. If it moves freely with light finger pressure, the turbo is fine and the actuator alone is the fix; stiff or gritty vanes mean soot-stuck vanes and the turbo has to come out.
2019 models specifically: TSB 18-066-23 covers a PCM software update for false P0299 codes, and a separate special-service procedure covers P0299 sensitivity on 2019+ trucks — have the dealer check for the flash before buying parts.
One 2019 owner's thread shows the frustration clearly: PCM flash cleared it, the code came back, and it still traced back to air-filter and sensor issues rather than a bad turbo. Work the tree, not the parts counter.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
NHTSA recorded 250 complaints for the 2014–2020 Ram 3500. 2016 was the worst year (134 complaints). Most-reported areas: engine, fuel/propulsion system, steering.
20V511000 (27/08/2020) — ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION Chrysler (FCA US LLC) is recalling certain 2019-2020 Ram 3500, 4500 and 5500 cab chassis built with a Cummins 6.7L High Output engine. Inadequate warmup protection can cause a lack of oil film on the engine connecting rod bearings while…
18V486000 (27/07/2018) — STRUCTURE:BODY:TAILGATE Chrysler (FCA US LLC) is recalling certain 2015-2017 RAM 1500, 2500, and 3500 pickup trucks equipped with a power locking tailgate and either a 5 foot, 7 inch or 6 foot, 4 inch bed. The tailgate actuator limiter tab may…
21V398000 (27/05/2021) — WHEELS:LUGS/NUTS/BOLTS/STUDS Chrysler (FCA US, LLC) is recalling certain 2012-2021 RAM 3500, 3500 Cab Chassis, 4500 Cab Chassis, and 5500 Cab Chassis vehicles. Incorrect information in the Service and Owner's Manuals may cause the flanged lug nuts to be over-tightened, which could…
22V035000 (27/01/2022) — VISIBILITY:WINDSHIELD WIPER/WASHER:LINKAGES Chrysler (FCA US, LLC) is recalling certain 2019-2020 Ram 2500 and Ram 3500 vehicles, Ram 3500 Cab Chassis, 4500 Cab Chassis, 5500 Cab Chassis and 3500 Cab Chassis with a gross vehicle weight rating (GVWR) of less than 10,000 lbs…
19V021000 (25/01/2019) — STEERING:LINKAGES:DRAG:LINK:CONNECTION Chrysler (FCA US LLC) is recalling certain 2013-2018 Ram 3500 and 2014-2018 Ram 3500 Chassis Cab and Ram 2500 vehicles. The outboard steering linkage jam nut may loosen, allowing one end of the drag link to separate.
20V043000 (24/01/2020) — POWER TRAIN:AUTOMATIC TRANSMISSION Chrysler (FCA US LLC) is recalling certain 2019-2020 Ram 2500 and 3500 Pickup vehicles equipped with six-speed automatic (68RFE) transmissions. A build up of pressure and heat inside the transmission may result in a transmission fluid leak from the dipstick…
26 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2014–2020 Ram 3500 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.