Community-sourced DIY repair guides for the 2008–2009 GMC Yukon Hybrid, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
Aux pump control module (bump/jerk + autostop stall) Factory-documented(6.0L V8)
The control module lives under the 12V battery in the front of the engine bay. A DIY-capable owner can swap the module and harnesses in under two hours, but the harness work is fiddly pigtail splicing, not plug-and-play.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
Torque specs
Aux pump control module and harness fasteners: verify — Torque specs for the module and harness fasteners not confirmed from a forum source — confirm against factory service info before torquing.
Tips
Know the pattern: the truck stalls or shuts off coming out of Auto Stop, sometimes with a bump or jerk as it switches between electric and engine modes. Codes P0AC4 (hybrid powertrain requested MIL), P2797 (aux pump performance), P0C2B (pump module feedback), and P0AB9 (autostop failed to restart) point at the aux pump circuit, not at the whole transmission.
Follow the owner-proven fix: replace the hybrid transmission (aux pump) control module plus the two harnesses. GM part 24261817 is the updated module; order connector pigtails 24259589 and 24259590 for 2008-2009 trucks. A 2008 Yukon owner did it himself in under two hours for about $500 in parts (another owner's parts quote was $292 shipped) and confirmed no stalls for more than a year afterward; a second 2008 Yukon owner replaced the module and wiring and eliminated the bump/jerk.
Heed the DIY warning from that owner: the harnesses are pigtail-only and are NOT a wire-for-wire swap — build the connections carefully per the bulletin. The truck needs a few days to relearn the new module and will not enter auto stop during the relearn.
Back it with GM's own preliminary information (NHTSA MC-10154554-9999), which names the module-and-harness swap as the first resolution for the bump/jerk symptom. If the module does not fix it, the next step is the aux pump itself (about $1,200), not a transmission rebuild.
Keep the differential in mind: one owner found P0AC4 can also indicate a dying hybrid pack — but the documented module fix held for over a year, so check the pack's cell-voltage spread before condemning it.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2008–2009 GMC Yukon Hybrid yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.